Smart
Version 0.11
14th April 2008
(Filename: sesmaexm.011)
Contents
Updates and Changes
- Updated German translations.
Known Issues
Updates and Changes
- Bugfix for reading multiple DTCs on 4Two MEG engine.
Known Issues
Updates and Changes
- KOMBI - communications improved during configuration.
- KOMBI - Addition of Configuration by function selection.
- KOMBI - Addition of Configuration by coding.
Known Issues
Updates and Changes
- KOMBI - fortwo instrumentation, component activation improved comms to configure the display as km or miles.
- KOMBI - install tachometer, following installation of tachometer, or corrupt configuration.
- KOMBI - general configuration - FUNCTION IS NOT GAURANTEED TO WORK SEE KNOWN ISSUES set tacho for Diesel (0-5000RPM) or Petrol (0-7000RPM) range.
Known Issues
- Use of General configuration on KOMBI, disables ABS check lamp when Diesel is selected.
Updates and Changes
- KOMBI - fortwo instrumentation, component activation added to configure the display as km or miles. Many vehicles revert to km display after low battery voltage condition.
- ESP - component activation added to calibrate steering angle sensor. This function is necessary following airbag replacement.
Known Issues
Updates and Changes
- MEG1.0 A batch of 24 previously unknown DTC's have been identified and implemented
Known Issues
Updates and Changes
- ABS comms on early fortwo now fixed. (Comms enabled with seperate message length byte).
Known Issues
Updates and Changes
Known Issues
- NOTE: 8th March 2007, ABS comms not working on all models .
Updates and Changes
- Release application in all langauges.
Known Issues
- Monitor list support only available on powertrain (forfour).
Updates and Changes
- Coverage extended to include forfour.
Known Issues
- Monitor list support only available on powertrain.
Updates and Changes
- Launch release of Smart application covering all 3 cylinder engined variants (forTwo and Roadster).
Known Issues
- Fails to read multiple dtc's on early MEG1.0 engine management.
|